8.6
Details of the process level
This level is active by default when the device is energized.
Value of the measured flow rate, displayed
12.6 L/S
in the unit chosen in the "UNIT" parameter of
the Parameters menu.
Value of the main totalizer, volume of fluid
87654 L
counted by the device since the last reset.
0......9
Value of the daily totalizer (identified by a
231 L.
dot after the volume units), volume of fluid
counted by the device since the last reset.
+
0......9
> 2 s
0......9
> 2 s
Activating the automatic scrolling of the values.
→
To stop the automatic scrolling, press any key.
Fig. 12 : Details of the Process level
20
Resetting the daily
totalizer.
English
Type 8025 / SE35, battery powered
Adjustment,Commissioning
8.7
Details of the parameters menu
To access the Parameters menu, simultaneously press keys
ENTER
for at least 5 s.
This menu comprises the following configurable parameters:
Choosing the display language
LANGUAGE
Choosing the flow rate unit, the number
UNit
of decimals and the unit the totalizers
are displayed in.
Entering the K factor of the fitting used
K-FACtOR
or have it calculated by a Teach-In
0......9
procedure.
Choosing the attenuation degree of the
FiLtER
changes of the displayed flow rate.
Resetting both totalizers.
tOtAL
END
Fig. 13 : Diagram of the Parameters menu