DeWalt DWE4202 Traduction De La Notice D'instructions Originale page 48

english
of the wire wheel or brush with the guard.
Wire wheel or brush may expand in diameter
due to work and centrifugal forces.
Additional Safety Rules for Grinders
• Threaded mounting of accessories must match
the grinder spindle thread. For accessories
mounted by flanges, the arbor hole of the
accessory must fit the locating diameter of
the flange. Accessories that do not match the
mounting hardware of the power tool will run
out of balance, vibrate excessively and may
cause loss of control.
• The grinding surface of the centre depressed
wheels must be mounted below the plane of
the guard lip. An improperly mounted wheel
that projects through the plane of the guard lip
cannot be adequately protected.
WARNING: We recommend the use of
a residual current device with a residual
current rating of 30mA or less.
Residual Risks
In spite of the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks cannot be avoided.
These are:
– Impairment of hearing.
– Risk of personal injury due to flying particles.
– Risk of burns due to accessories becoming hot
during operation.
– Risk of personal injury due to prolonged use.
– Risk of dust from hazardous substances.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
DATE CODE POSITION
The date code, which also includes the year of
manufacture, is printed into the housing.
Example:
2015 XX XX
Year of Manufacture
46
Package Contents
The package contains:
1 Angle grinder
1 Guard
1 Side handle
1 Flange set
1 Hex key
1 Instruction manual
• Check for damage to the tool, parts or
accessories which may have occurred
during transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fig. 1, 2)
WARNING: Never modify the power
tool or any part of it. Damage or personal
injury could result.
A. Spindle lock button
B. Spindle
C. Side handle
D. Backing flange
E. Threaded locking flange
F. Guard
G. Slider switch (DWE4204, DWE4205, DWE4206,
DWE4207, DWE4214, DWE4215, DWE4216,
DWE4217)
H. Paddle switch (DWE4202, DWE4203,
DWE4213)
I. Lock-off lever (DWE4202, DWE4203,
DWE4213)
J. Guard release lever
K. Dust ejection system
INTENDED USE
The DWE4202, DWE4203, DWE4204, DWE4205,
DWE4206, DWE4207, DWE4213, DWE4214,
DWE4215, DWE4216 and DWE4217 heavy-duty
small angle grinders have been designed for
professional grinding, sanding, wire brushing and
cutting applications.
DO NOT use grinding wheels other than centre
depressed wheels and flap discs.
DO NOT use under wet conditions or in the
presence of flammable liquids or gases.
These heavy-duty angle grinders are professional
power tools.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.