DS Produkte GT-E816-07 Mode D'emploi page 23

■ To ensure that the mains cable does not become hot during operation, pull out at
least two thirds of its total length from the device. Do not pull out the mains cable with
force up to its maximum length (not further than the red marking) in order to prevent
damage!
■ Before a nozzle is replaced, always switch off the device fi rst and pull the mains plug
out of the plug socket!
■ On no account should the device be used to suck up the following:
– liquids or wet substances (e.g. wet carpet shampoo)
– glowing ash, cigarette ends, matches, etc.
– infl ammable or explosive substances
– very fi ne dust (e.g. concrete dust), ash or toner
– pointed, hard objects such as large pieces of broken glass
The device has a dust level indicator (14). If it is red during use, the dust contain-
er (2) is full or the suction nozzle, the suction hose (9) or the telescopic tube (5) is
blocked. In this case, empty the dust container (2) (see the "Cleaning" chapter) or
remove the cause of the blockage (see the "Assembly" chapter).
1. Make sure that the accessories are attached correctly to the device (see the "Assem-
bly" chapter).
2. Pull the mains cable out of the housing as far as the yellow marking. Do not pull it any
further than the red marking!
3. Insert the mains plug into a properly installed plug socket that is easily accessible.
4. Press down the
5. Guide the nozzle over the surface to be cleaned. The vacuum cleaner can be pulled
along like a sledge during cleaning.
6. Press the On / Off switch (13) again after vacuuming to switch off the device.
7. Pull the mains plug out of the plug socket, hold the mains cable securely and press
the button for winding up the cable (11). Holding the mains cable prevents any
"whiplash" effect of the mains cable.
8. To ensure optimum performance of the device, clean the dust container (2) and all
fi lters regularly (see the "Cleaning" chapter).
23
On / Off switch (13) to switch on the device.
Tip: The handle (8) is equipped with an exhaust air
valve (7). To reduce the suction force when vacuum-
ing upholstery, rugs or light, movable objects, open
the exhaust air valve (7) by sliding. Normally the ex-
haust air valve (7) should be closed so that the suc-
tion force is not unnecessarily reduced.
EN