Tandberg Data SLR Serie Manuel D'installation Et Guide De L'utilisateur page 60

Tandberg Data
56
Installation
1) Login as root.
2) Type the following command: MKDEV TAPE.
3) Select Install a SCSI Tape Drive.
4) Enter the prefix of the SCSI host adapter that supports
this device.
(Typing h gives you a list of the supported SCSI host
adapter).
5) Which SCSI host adapter supports this device?
(If only one SCSI host adapter in installed select 0. If
two SCSI host adapter of the same type are installed,
select 1).
6) What is the target ID for this device? (2 is the Tandberg
7) What is the LUN of this device?
(Must be set to 0).
8) Update the SCSI Configuration?
(Check first that the table on the screen is conformed to
the Tape Drive configuration).
NOTES:
- The Kernel has to be rebuilt to reflect the new Hardware configuration,
and a reboot is mandatory before you can use your SLR tape drive. -
For any questions related to this operating system or its embedded
Backup applet, please refer to the documentation provided on the
SCO OS CD-ROM.
default SCSI-ID)
Tandberg SLR Installation and User's Guide