Tandberg Data SLR Serie Manuel D'installation Et Guide De L'utilisateur page 21

Internal Tape Drive Installation
1) Internal installation of the drive requires that there is a free 5.25-inch bay with
an open front in your computer system. Obtain access to the removable media bay
(refer to the documentation supplied with your system for more information on
accessing the removable media bay).
Tandberg SLR2
Tape Drives
NOTE:
A mounting kit may be necessary for mounting the tape drive into the bay. Please refer to
www.tandberg.com
on obtaining the kit.
3) Secure the tape drive to the bay (use only the screws supplied with the tape drive)
4) Connect the power cable and the SCSI signal cable (and eventually the SCSI
converter), as shown below:
Tandberg SLR2
Tape Drives
Tandberg SLR Installation and User's Guide
SLR5
®
> SUPPORT >SLR Support > Hardware Compatibility for more information
SLR5
®
Tandberg SLR24, SLR40, SLR50, SLR60,
SLR75, SLR100 and SLR140 Tape Drives
Tandberg SLR24, SLR7, SLR40, SLR50, SLR60,
SLR75, SLR100 and SLR140 Tape Drives
Tandberg Data
17