Tandberg Data SLR Serie Manuel D'installation Et Guide De L'utilisateur page 24

Tandberg Data Tandberg Data
Please carefully read the Information about the SCSI-ID conflicts and SCSI
termination paragraph on pages 11-14. To install a tabletop tape drive, simply
connect the tape drive to your PC/Server with the enclosed SCSI cable to any of the
two available SCSI connectors. Remember to place the termination on the free
connector on the back of the tape drive, and to select a unique SCSI-ID.
SLR2-5
ON/OFF Cooling
Switch Fan
AC Power
Receptacle
20
SCSI-ID Thumb-
wheel Switch
SCSI Interface
Connectors
Connect it then to the power outlet.
When you power up the system for the first time, and check that
all your SCSI devices are visible for the SCSI controller board.
ON/OFF Cooling
Switch Fan
AC Power
Receptacle
Tandberg SLR Installation and User's Guide
SLR7-140
SCSI-ID Thumb-
wheel Switch
SCSI Interface
Connectors