Taconova ES 5941 Manuel D'utilisation page 86

Info and menu parameters
KOM03 TOTAL
FAULT MES-
SAGE
KOM04 EBUS
ADDRESS
KOM05 EBUS
SUPPLY
STE CONTROLS
STE11 TPV SENSOR
TYPE
STE12 MIN.RUN-
TIME TPV
PROTEC
STE13 MIN.OFF-
TIME TPV
PROTEC
MAN MANUAL
MAN01 SPEED PRIM.
PUMP
MAN02 SPEED CIRC.
PUMP
MAN03 RETURN
FLOW
SWITCH
04/2021 Item no. 215790 EA no. 1321
Option: Fault Here, the fault messages and info
message messages are also diverted to the
output output.
n
-1: No voltage is output if there
is a total fault message pending.
n
0: This function is not used.
n
1: Voltage is output if there is a
total fault message pending.
eBUS address Addressing of the controller in the
eBUS network
Voltage supply for eBUS communi-
cation, max. load 180 mA.
n
TPV PWT pri- 0: NTC 5K
mary flow
n
1: PT 1000
sensor selec-
tion, sensor
type
Min. runtime Is active if the temperature at TPV
for primary falls below the value TPVset. This
pump cycle/ serves to protect the heat source
protective from cooling down too signifi-
function cantly. The value specifies the
minimum runtime/test time in
which the temperature is not per-
mitted to drop.
Waiting time Is active because TPV has fallen
for the primary below the value TPVset after the
pump cycle/ minimum runtime; the pump
protective remains blocked for the setting.
function This allows the heat source to
increase the temperature again.
Adjuster only has an effect if the operating mode selection is "Manual"
Manual value Primary pump (FRIWA; PP)
output
Manual value Circulation pump WWC
output
Manual value Return flow switch valve VSR
output
-1;0;1
2...16
on/off
0...1
0...180
0...60
0...100
0...100
on/off
Operating instructions
ES 5941
0 25 08:111
- 25 04:020
- 25 04:036
- 25 28:027
s 25 36:025
min 25 36:026
.
% 0 08:088
% 0 05:122
- 0 05:120
33