Troubleshooting Support; Error Message - Taconova ES 5941 Manuel D'utilisation

Troubleshooting support

7 Troubleshooting support
Discovery
Nothing shown on the display
Status display
04/2021 Item no. 215790 EA no. 1321
If no base image or error message is shown on the
display after switch-on, the explanations in the fol-
lowing table may be of use.
Possible cause
Controller is not switched on.
External switch is set to OFF.
Wiring is faulty.
STA01 STATUS
n
5: Fault
n
7: Warning
STN1...5 STATUS STATION CAS.
n
104: Error
ZIR07 CIRC. CALIBRATION
n
11: Error – Flow despite being
switched off.
n
12: Error – Flow rate fluctuations
too great when the pump is
switched on.
Operating instructions
Remedy
Check the fuses and set the
external switch to ON.
Open the controller and check the
wiring!
Return to the start page in order to
read the ERROR or INFO code. For
further information, see
7.1 "Error message" on page 48
Ä Chapter 7.2 "Info message"
and
on page 49 .
Return to the start page in order to
read the ERROR or INFO code. For
further information, see
7.1 "Error message" on page 48
Ä Chapter 7.2 "Info message"
and
on page 49 .
n
Check the hydraulics, SEK04
FLOW RATE DHW > STE15 MIN
FLOW RATE, tapping active or
external circulation
n
Check the pump, SEK04 FLOW
RATE DHW> ZIR08 FLOW RATE
CIRCULATION + ZIR05 TOLERANCE
CALI. CIRC
ES 5941
Ä Chapter
Ä Chapter
47