Tool Operation - DeWalt P35s Mode D'emploi

TOOL OPERATION

training in this manual before attempting to operate the tool. (Check to be sure the
tool is not loaded, the piston moves freely within the barrel, and no foreign objects or
fasteners are in the barrel.) Perform the daily function test before using the tool.
OPERATION
1. Always load the fastener before inserting powder load to prevent injury to the
1
Note:
selection section of this manual.
2. Always point the tool in a safe direction away from bystanders and the operator. In
2
3. Insert the powder load strip into the bottom of the tool handle starting with the
3
4. To make a fastening, place the tool against the work surface. Hold the tool firmly
4
Note:
to hold the tool depressed against the work surface for at least 30 (thirty) seconds
in case of a delayed load discharge. Then carefully remove the entire load strip and
dispose of it in a can of water or other non flammable liquid. Never attempt to force or
pry a load out of a tool chamber. Do not discard unfired loads into a trash container.
5. To prepare for the next fastening, point the tool in a safe direction. Always insert
tool as improper handling may cause it to discharge and strike the operator and/or
bystander. A jammed tool must be pointed in a safe direction at all times. Tag the tool
and lock it up. Call your DEWALT representative for proper assistance.
P35s
CAUTION: Be sure to read and understand all of the safety precautions and
operator or bystanders in the event of an accidental discharge. Place the fastener,
point out, into the end of the guide until the fluted tip fits inside. Do not use
excessive force when inserting the fastener. If excessive force is required, stop
and determine why the fastener can not be inserted. Correct the problem before
proceeding.
Do not use fasteners longer than 1-1/2" (38mm) as listed in the fastener
one movement, slide the barrel forward then close it against the stop. The barrel
should be pulled fully forward to reset the piston for the next fastening. Loss of
power may result from an im properly positioned piston.
Do not attempt to close the tool by exerting force on the front of the barrel. Never
place your fingers or hands over muzzle end of the tool. The safe position for hands
and fingers are as shown in the diagram. Hands must never be placed in front of
the tool muzzle or barrel. In the event of an accidental discharge, the piston and/or
fastener can pass through the operator's hand.
lowest power level, 3 / Green. The strip should be inserted completely and should be
flush with the bottom of the handle. Always insert the strip from the bottom of the
handle. If this load does not fully set the fastener, try the next higher power level until
the proper level is found.
WARNING: Over driving or over powering a fastener can cause a safety hazard.
with two hands and completely depress the barrel. Then squeeze the trigger.
Always hold the tool perpendicular to the work surface. Hold the tool firmly against
the work surface to avoid excessive recoil. Never depress the tool against anything
except the work surface.
In the event that the load does not discharge after the trigger is pulled, continue
a new fastener before loading or advancing the powder load strip. Insert the fastener
as described in Step 1. Once the fastener is inserted, cycle the tool as described in
Step 2. Repeat this procedure for subsequent fastenings. When the ten load strip
has been completely fired, remove it by pulling it from the top of the tool body.
WARNING: Do not attempt to unload or disassemble a jammed, stuck or broken
EN
9