Mounting The Wing - Reely Cessna 182 Rtf Notice D'emploi

c) Mounting the Wing
• Insert the three plastics pegs of the wing
support (see figure 8, pos. 3) exactly into the
corresponding recesses in the top edge of the
cockpit (1).
• When carrying out this step with the model with
item no. 233770, ensure that the connecting
cables of the ailerons are not jammed between
the wing and the wing support on the fuselage.
Try to guide the cables as far as possible to
the front part of the model, so as not to impair
the moveability of the rudder and elevator
servos.
• When the wing sits on the fuselage without
leaving a gap, fix it with the two plastics screws
(2) in the rear part.
Tighten the screws to an equal degree so that
the wing rests straight on the fuselage.
58
Figure 9a
Figure 9b