Basic Functions; Switching The Mobile Phone On And Off - DS Produkte Handy für alle Premium V703 Mode D'emploi

Prior to first use, if the battery symbol at the top right on the display does
not show any bar or the mobile phone can no longer be switched on, the bat-
tery needs to be charged up. The mobile phone can be both switched on and
switched off as this happens.
3. After connection, the charge progress bar is shown in the battery symbol.
After a little while, the display lighting automatically switches off. To switch
it on, briefly press the
You can use the mobile phone during the charging process (with the
exception of the first charging process).
If the battery is completely dead, it may take a few minutes before the
mobile phone shows that it is being charged and can be used to make
phone calls.
4. Once the battery is charged up, all three bars are shown in the battery
symbol.
5. First disconnect the adapter from the mains and then remove the USB ca-
ble from the device and the mains adapter. Store the cable and the mains
adapter in a dry place that is not accessible to children and animals.

Basic Functions

Switching the Mobile Phone On and Off

1. To switch on the mobile phone, press the
2. After switching on the phone, an input field will appear on the display for
you to enter your PIN. You will receive the PIN when you purchase your
SIM card (see the "What You Should Know About the SIM Card" chapter).
3. Enter your four-digit PIN and confirm by tapping the key. Your mobile
phone is now ready for operation.
1. Connect the USB cable that is supplied to the
Mini-USB socket (17) of the mobile phone and the
mains adapter.
2. Connect the mains adapter to a properly installed
and easily accessible mains socket. The mains volt-
age must match the technical data for the mains
adapter (see the "Technical Data" chapter).
key.
53
key for approx. two seconds.