Assembly; Saddle Height - SQlab 611 ERGOWAVE Manuel De L'utilisateur

Assembly

Warning
Incorrectly mounted components pose a significant risk.
• You must read and understand the instructions and notes before you begin assembly.
• If you have any questions about mounting these components, contact your SQlab dealer or have the saddle fitted by an experi-
enced bicycle mechanic.
Caution
Country-specific standards, rules and regulations must be observed for equipment on eMTB, eBikes and Pedelecs.
• In Germany, observe the "Guide to Conversion to Pedelecs" of the Zweirad-Industrie-Verband e.V. (http://www.ziv-zweirad.de) in
cooperation with the association service and bicycle geV (www.vsf.de) and Zedler - Institute for Bicycle Technology and Safety
GmbH (www.zedler.de).
• The SQlab ERGOWAVE ® saddles have NOT received blanket approval for fast pedelecs (S-Pedelecs, up to 45 km/h). Observe the
country-specific specifications for these. In Germany, particularly the "Guidelines for component replacement on fast e-bikes/
pedelecs with pedal assistance up to 45 km/h" must be observed.

Saddle height

For information about how to correctly adjust the saddle height, refer to your bike's guide, and to a variety of books and guides on cycle
ergonomics. Your SQlab dealer will certainly be happy to help you.
Due to the SQlab step saddle concept, SQlab saddles are usually a bit taller on top than other saddles. Therefore, after replacing the
saddle it is necessary to review and possibly adjust the seat height.