Assembly Compatibility And Operational Safety - SQlab ERGOLUX Mode D'emploi

Assembly compatibility and operational safety

The saddles in the SQlab ERGOLUX
metallic alloy. With few exceptions, these can be mounted on most standard seat posts.
The functional principle, the clamping forces and the quality of workmanship, especially
the contact surfaces and edges of the seat post can affect the durability of the saddle or
its saddle frame and possibly cause damage.
Never mount your SQlab ERGOLUX
posts that meet the following criteria:
series have round struts, which are in common use, with a diameter of 7 mm and are made of a
®
saddle on unsuitable seat posts, but only on seat
®
OK

OK

OK

The clamping of the struts must have a length "A" (or seat post
distance) of at least 32 mm. The minimum length "B" and "C"
of each individual clamping surface must be at least 7 mm.
Length "A" of the upper clamping jaw must be at least 32 mm
and positioned within the perhaps longer lower jaw "B".
Even for seat posts with a clamping mechanism that is trans-
verse to the direction of travel, the clamping length "A" must
be at
least 32 mm
Warning
Always follow the instructions and
warnings given in the assembly
and operating instructions for your
saddle.