Care; Material Defect Liability And Warranty - SQlab ERGOLUX Mode D'emploi

Care

Clean the saddle regularly with water and a soft cloth. If heavily soiled, a commercially available rinsing or cleaning agent and warm
water can also be used.
Warning
Never use high pressure cleaners, cleaning cloths or sponges with particularly rough or grainy surfaces, solvents or other aggressive
cleaning agents such as acetone, (nitro) thinner, mineral spirits or trichlorethylene for cleaning. This could damage the cover of the
saddle, the saddle shell and the material of the struts.
Note
Note
Noises such as creaking, crackling, squeaking are annoying and the cause is usually difficult to figure out. The most common
cause of noises from the saddle area is the saddle clamping. Make absolutely sure that the clamping surfaces of the seat post
and the clamping area of the seat stays are free from dirt. However, the connection between the seat post and frame to the bot-
tom bracket often makes a noise. The connection of the struts to the saddle can also cause noise. Lightly spraying oil or creep
oil in the space between saddle stays - saddle shell helps. It is usually the rear linkage that is causing noises. Oiling must be
repeated approximately every 2-3 trips at first. After some time, no noise should be produced even without regular lubrication.
To find out the actual cause of the noise, it is recommended to only oil the front or the rear connection between saddle strut and
saddle shell at first.

Material defect liability and warranty

Within the EU, all purchase contracts between private individuals and commercial sellers are subject to statutory warranty. From the date
of purchase, buyers have a2 year warranty. In the event of a defect or a warranty claim, the SQlab partner from whom you purchased the
product is your contact.
Note
Note
This rule applies only in European countries. Check with your SQlab dealer for any
deviating regulations in your country.
The following specialist dealer guarantee is in addition to the legal material defect liability of your contractor and does not affect them.
1. In addition to the statutory liability for defects, SQlab GmbH has extended its purchase to specialist retailers in Germany
Products the manufacturer's warranty from 24 to 36 months.
In the event of a defect or a warranty request, your SQlab dealer is the contact person.
The following end customer warranty is in addition to the legal defect liability of your contractor and does not affect them.
1. For irreparable damage to your SQlab product caused by a crash, SQlab GmbH offers you
a discount of 50% up to 10 YEARS FROM THE DATE OF PURCHASE WHEN PURCHASING A NEW SQLAB REPLACEMENT PRODUCT.
If you would like to use the crash replacement, send us your defective product to the following address:
SQlab GmbH
Crash Replacement
Postweg 4
D- 82024 Taufkirchen