Rear Of Saddle/Horizontal Positioning Of Saddle - SQlab 611 ERGOWAVE Manuel De L'utilisateur

Rear of saddle/horizontal positioning of saddle

At first mount the saddle in the middle of the clamping area. Vary the position backwards and forwards according to your requirements,
starting from the middle position within the adjustment range. For information on how to proper ly adjust the position of the saddle, refer
to your bike's guide, and to a variety of books and guides on bike ergonomics. Your SQlab dealer will certainly be happy to help you.
Tip: The SQlab ERGOWAVE ® saddle should tend to be pushed a little farther forward than your previous saddle.
Warning
The SQlab 613 Ergowave R is a saddle especially designed for time trial and triathlon. In addition to the development according to
ergonomic aspects, we have also observed the strict rules of the UCI. Therefore the saddle fulfills all measurements given by the
UCI. When mounting, make sure that the saddle is mounted horizontally. For a UCI conform assembly the saddle tip must be at least
5 cm behind the center of the bottom bracket.
Clamp your SQlab ERGOWAVE ® saddle only within the scale shown on the saddle struts.
Note: In the case of a longer lower clamping jaw, make sure that the saddle is not defor-
med during tightening.
Warning
If the clamping is outside the specified range, product safety may become impaired
and damage with breakage could occur. In such a case, the saddle frame could sud-
denly break without warning during use and lead to an accident.
If in doubt about the right setting, please contact your dealer.