Rear Of Saddle/Horizontal Positioning Of Saddle - SQlab 600 active Mode D'emploi

Rear of saddle/horizontal positioning of saddle

First mount the saddle in the middle of the clamping area. Vary the position backwards and forwards according to
your requirements, starting from the middle position within the adjustment range. For information on how to properly
adjust the position of the saddle, refer to your bike's guide, and to a variety of books and guides on bike ergonomics.
Your SQlab dealer will certainly be happy to help you.
Tip: The SQlab 600 active saddle often needs to be pushed a little further forward than your previous saddle.
Clamp your SQlab 600 active saddle only within the scale shown on the seat stays.
Note: In the case of a longer lower clamping jaw, make sure that the saddle is not defor-
med during tightening.
Warning
If the clamping is outside the specified range, product safety may become impaired
and damage with breakage could occur. In such case, the saddle frame could sudden-
ly and unexpectedly break during use and an accident may occur.
If in doubt about the right setting, please contact your dealer.