Tightening Torque - SQlab 611 ERGOWAVE Manuel De L'utilisateur

Tightening torques
Warning
When mounting your 6OX Trial Fabio Wibmer only the mounting on a so called Tripod seat post is possible. Please note the torque
for the screw, which is specified by the manufacturer of the seat post. Please make sure that a torque of 12 Nm is not exceeded.
Warning
The tightening torque of the clamping screws on the seat post depends on the seat post model. However, do not use a seat post for
which the tightening torque of the bolts on the seat stay clamp specified by the manufacturer is greater than 18 Nm (12 Nm 6OX Trial
Fabio Wibmer). Exceeding the tightening torque can lead to fibre cracks or pinching, which can cause a steering failure that could
cause a crash.
Warning
Even a short ride with one or more loose screws on the seat post can damage the seat stays so much that they can no longer be used
safely.
• Check the tightening torque of the clamping screws on the seat stays after 20–50 km and then at least FOUR TIMESannually for the
correct torque and tighten if necessary. When checking the tightening torque, make sure not to exceed the maximum tightening torque.
• Never ride with a loose saddle.
Observe the tightening torque of the saddle clamping stated in the operating inst-
ructions for your seat post.
Never exceed the maximum tightening torque of 18 Nm. If the torque specifications
are inconsistent, please contact your dealer.
A tightening torque above 18 Nm may lead to an impairment of product safety and
damage with consequent bre akage. In such case, the saddle frame could suddenly
break without warning during use and lead to an accident.
NOT
OK