Hitachi N 3808AP Manuel D'instructions Et De Sécurité page 19

Push lever
Trigger
● A staple will fi re each time the trigger
is depressed as long as the push lever
remains depressed.
(2) Continuous operation (Push lever fi re)
Using CONTACT ACTUATION MECHANISM
● To avoid double fi ring or accidental fi ring due
to recoil.
1) Do not press the stapler against the
workpiece with excessive force.
2) Separate the stapler from the workpiece
as it recoils after stapling.
● If the hook is affi xed, do not operate with
CONTACT ACTUATION MECHANISM.
1 Pull the trigger with the Stapler off the workpiece.
2 Depress the push lever against the workpiece to
drive a staple.
3 Move the Stapler along the workpiece with a
bouncing motion.
Each depression of the push lever will drive a
staple.
As soon as the desired number of staples have been
driven, remove fi nger from the trigger.
2
3
WARNING
WARNING
Push lever
Previously
pull the trigger
(3) Single sequential operation (Trigger fi re)
● To avoid double fi ring or accidental fi ring due
to recoil.
1) Pull the trigger rapidly and fi rmly.
1 Position the staple outlet on the workpiece with
fi nger off the trigger.
2 Depress the push lever fi rmly until it is completely
depressed.
3 Pull the trigger to drive a staple.
4 Remove fi nger from the trigger.
To continue stapling in a separate location, move the
stapler along the workpiece, repeating steps 1 – 4 as
required.
2
3
Push Lever
English
3
1
WARNING
Trigger
19