Battery Operation Of The Kts 650; Touchscreen With Stylus; Virtual Screen Keyboard With Stylus; Brightness Control - Bosch KTS 650 Instructions D'emploi

en  | KTS 650 | Operation
4.5.

Battery operation of the KTS 650

The integrated fully-charged battery in the KTS 650 is
set up as a buffer battery, in order to provide approx.
1 hour of autonomous operation. Make sure, therefore,
that where the KTS 650 is used for longer than this
period, a permanent external power supply is available
(vehicle or power pack).
The charging of the battery is controlled automatically
in the KTS 650. Whenever the KTS 650 is connected
to the power pack or to the vehicle battery (via the
connected diagnostic cable/adapter lead to the
diagnostic plug in the vehicle), the battery is charged
(see also Chapter 2.4.2). If the battery charge is at less
than 20 %, it emits a warning signal (beep). Charge the
battery up again immediately. You can read the battery
charge state at any time on the energy display. The
battery charge state is displayed in the menu
control Energy options
–>
i
The battery power display only gives a precise
statement of the battery capacity after several
charge and discharge cycles.
4.5.4

Touchscreen with stylus

The touchscreen of the KTS 650 is operated with the
stylus. The stylus basically has the same functions as a
mouse. A single click with the left mouse key conforms
to a single touch of the stylus on, for example, an
icon or the positioning of the cursor on an entry field.
A double click with the left mouse key conforms to a
double touch of the stylus on the touchscreen. This
is used to start an application program, for example.
Clicking with the right mouse key conforms to a
press of the stylus on the touchscreen for more than
2 seconds and opens up any available auxiliary menus.
i
Alternatively, a mouse can be used via the USB
connection.
1 689 979 856 | 2007-05-04
System
Energy display
–> .
4.5.5

Virtual screen keyboard with stylus

The KTS 650 provides you with a virtual keyboard.
By clicking the icon in the taskbar, the virtual
keyboard is opened up.
By clicking the shft key, the keyboard changes over to
upper case letters and special characters. Clicking the
shft key again changes the keyboard back to lower case
letters and figures.
4.5.6

Brightness control

The brightness control menu is called up on the display
by clicking with the stylus on the
By clicking the + field, the display becomes brighter,
and by clicking the — field, it becomes darker.
i
Different brightness values are saved for battery
operation and for the external power supply.
4.5.7 PS/ keyboard
To connect, insert the connector from the PS/2
keyboard into the appropriate plug socket on the
terminal strip of the KTS 650 (Fig. 3, Item 12).
i
When using a PS/2 keyboard, you must select
the appropriate country-specific keyboard during
start-up in the start screen "Diagnostics Software
Selection" under "System Control » Configuration »
Settings".
i
When using the equipment with the PS/2 keyboard,
it must be ensured that the "Num" pilot lamp is
alight, as otherwise no figures can be entered with
the number keys. The Table below will explain the
most important functions of the keyboard to you.
icon in the taskbar.
Bosch Diagnostics