Replacing The Battery - Bosch BAT 131 Notice Originale

en �2 � B�T ��� � Maintenance & Troubleshooting
6.4 Changing The Cable �ssembly
1. Identify the circled screw on the back of the tester.
2. Remove the screw.
3. Grasp the housing and firmly pull the cable assembly
from housing.
4. To attach a new cable, align the cable and tester
housings and push together.
5. Insert the screw and tighten.
|
1 689 989 132 2011-09-09
6.5

Replacing the Battery

This B�T ��� is subject to European guideli-
nes 2002/�6/EG (WEEE).
Old electrical and electronic devices, including-
cables and accessories or batteries must be
disposed of separate to household waste.
¶
Please use the return and collection sys-
tems in place for disposal in your area.
¶
Damage to the environment and hazards to
personal health are prevented by properly
disposing of BAT 131.
The BAT 131 can test down to 5.5 volts when the unit's
internal batteries are not functioning. The tester dis-
plays LOW INTERNAL AA BATTERIES, REPLACE
AA BATTERIES SOON! when the internal AA batteries
need to be replaced.
i
Setup information will be retained while you change
the internal batteries.
Use the following procedure to remove and replace the
internal AA batteries:
1. Turn BAT 131 face down.
2. Remove the screw securing the battery compartment
cover using a small Phillips screwdriver.
3. Lift the door off and remove the discharged battery.
4. Insert fresh AA batteries making sure the positive
and negative terminals are positioned correctly.
5. Reposition the cover and tighten the screw.
Robert Bosch GmbH