Kts; 19 5.1.2 Data Carrier; 19 5.1.3 Dvd Drive; Spare Parts And Parts Subject To Wear - Bosch KTS 650 Instructions D'emploi

en 6 | KTS 650 | Maintenance
5. Maintenance
5.1 Cleaning
5.1.1

KTS 650

The housing and the display of the KTS 650 may only
be cleaned with soft cloths and with neutral cleansing
agents. Do not use any abrasive cleansing agents or any
rough workshop cleaning cloths!
5.1. Data carrier
Clean the CD-ROM or DVD-ROM with a disk cleaning kit
or wipe the silver side of the disk carefully with a soft,
lint-free cotton cloth. Do not use a paper towel, as this
can lead to scratches being formed.
5.1. DVD drive
Clean the DVD drive regularly with a cleaning disk for
the CD-ROM or DVD drive. These cleaning disks can be
obtained from the majority of computer or consumer
electronics retailers.
5. Spare parts and parts subject to
wear
Description
KTS 650
Power pack 90/264 V AC
mains power cable
(<)
OBD interchangeable adapter cable
adapter insert
(<)
Measurement cable, red
(<)
Measurement cable, blue
(<)
Measurement cable, yellow
(<)
Ground lead, black
(<)
Test prod, red
(<)
Terminal clip, black
(<)
Y-connecting cable for supply
Stylus
(<)
Case
Fuse (5 AF)
(<)
UNI connecting cable
(<)
External DVD drive (only 0 684 400 651)
USB connecting cable
(<)
Battery pack with calibration CD
Table 3: Spare parts and parts subject to wear
Parts subject to wear
(<)
1 689 979 856 | 2007-05-04
Order Number
1 687 022 944
1 687 022 890
1 684 461 106
1 684 465 520
1 688 000 346
1 684 430 065
1 684 430 066
1 684 430 067
1 684 430 068
1 684 485 035
1 684 480 022
1 684 448 309
(<)
1 683 083 004
1 685 438 144
1 684 520 038
1 684 465 488
1 687 022 967
1 684 465 491
1 687 335 026
(<)
5. Battery change
If handled incorrectly, there is a risk of
ignition, bursting and combustion!

Do not heat, burn, short-circuit or mechani-
cally damage the battery pack, and do not
charge it with excessive current or with the
poles incorrect!

Suitable extinguishing agents: Water, CO
sand.
!
Only use the original Bosch battery pack for the
KTS 650! The smart rechargeable battery chip must
be reprogrammed every time the battery is replaced.
Used battery packs must be disposed of according
to the valid guidelines.
5..1 Removal
CAUTION – Risk of irreparable damage.
Touching an incorrect pin can cause severe
damage to the circuit board .

Ensure that the battery connector is posi-
tioned correctly.
1. Turn off the KTS 650.
2. Unscrew the screws (1) on the rear of the KTS 650
unit and lift the cover panel (3).
3. Disconnect the fan connection (2).
4. Unscrew the screws (4) on the top of the battery
cover panel (5) and remove the cover panel.
5. Remove the battery pack (7) and disconnect the
battery connection (6).
1
3
4
4
5
6
7
,
2
2
1
Bosch Diagnostics