Floor Bracket - GE GBC12IAX Manuel D'utilisation Et D'installation

INSTALLING THE ANTI-TIP FLOOR BRACKET
WARNING
Under certain circumstances, this refrigerator
can tip forward.
Injury to persons can result.
Install the Anti-Tip Bracket packed with this
refrigerator.
MEASURE CABINET OPENING
1
AVAILABLE VS. REFRIGERATOR WIDTH
Measure the width of the cabinet opening
where the refrigerator will be placed, W.
Be sure to account for any countertop
overhang, baseboard thickness and any
clearance desired. Width, W, should not be less
than 28 inches. The refrigerator will be placed
approximately in the middle of this opening.
Rear Wall
W
REFRIGERATOR
Front
Installation Instructions
Baseboard
Thickness
or Countertop
Overhang
(Whichever Is
Greater) Plus Any
Desired Clearance
RH Side
15
LOCATING THE ANTI-TIP
2

FLOOR BRACKET

Place the anti-tip floor bracket locator template
A
(included inside the anti-tip kit) onto the floor
up against the rear wall, within W and in line
with the desired location of the RH side
of the refrigerator (see Figure 1).
Figure 1 – Installation Overview
Floor – Concrete
(2 Holes)
Floor – Wood
(2 Holes)
Hole
for Anti-Tip
Bracket
Place the anti-tip floor bracket onto the locator
B
template with its RH floor holes lined up with
the floor holes indicated on the template sheet,
" from the edge of the sheet
approximately 6 5 ⁄
8
or the RH side of the refrigerator.
Hold the template down in position and use the
C
anti-tip floor bracket as a template for marking
the holes based upon your configuration
and type of construction as shown in Step 3.
Mark the hole locations with a pencil, nail
or awl.
NOTE: It is REQUIRED to use at least 2 screws
to mount the floor bracket (one on each side
of the anti-tip floor bracket). Both must be into
either the wall or the floor. Figure 2 indicates
all the acceptable mounting configurations for
screws. Identify the screw holes on the anti-tip
floor bracket for your configuration.
2 Wall Holes
Floor Bracket
to Install
RH Holes
"
6 ⁄
5
8
Rear RH Corner
of Cabinet Wall
RH Side of
Locator Template
Refrigerator
Sheet