Graef ES 80 Notice D'utilisation page 44

Espresso Machine ES 80 / ES 81
Steam Wetness or Steam
Pump Rate
EN
The steam pump rate of this unit
has been pre-set. Modifying the
steam pump rate enables you to
make the steam wetter or dryer
and aids in the delivery of a po-
werful, dry steam - ideal for tex-
turing milk. The steam pump rate
can be modified in flow rate in-
crements up or down should it be
desired.
To do this you need to follow the
instructions below:
Press the "HOT WATER" button
for 3 seconds.
While still holding down the
"HOT WATER"button
press the "POWER" button and
release.
Release "HOT WATER"button.
This activates the programmabi-
lity of the steam pump rate and
to signal this, the unit will out-
put the current setting with a se-
quence fo beeps.
Beep Sequenze
3 short Beeps
2 short Beeps
1 short Beep
1 short und 1
long Beep
1 long Beep
2 long Beeps
3 long Beeps
44
briefly
Setting
+ 3
+ 2
+ 1
Factory Setting
- 1
- 2
- 3
important!
The lights behind the "COFFEE"
and "STEAM" buttons will start
flashing.
Within 30 seconds press and re-
lease one of the flashing buttons
depending on the required tem-
perature adjustment.
Up (+) a setting : Press "STEAM"
Down (-) a setting : Press "COFFEE"
important!
When you have selected a
new temperature setting the
unit will sound a sequence
of beeps to indicate the new
temperature setting.
To save your settings press and
hold down the "HOT WATER"
button for 3 seconds. A single
long beep will sound to indicate
your settings have been saved.
important!
The unit will then automa-
tically power on and begin
heating up.
The unit will stay in pro-
gramming mode for up to
30 seconds. If you do not se-
lect a new temperature set-
ting within 30 seconds the
programm will automatically
return to the Factory Setting
and the unit will the power
on and begin heating up.