Sentiotec Pro C3 Instructions D'installation Et D'utilisation page 82

Installation instructions, only for experts
4. Turn the bottom knob to the left.
► In the bottom display, "SEnS" appears.
► The heater temperature (F1) is displayed as the actual temperature in
the single-sensor mode.
Decreasing the maximum temperature to 105 °C
The preset temperature can be set to between 30 °C and 110 °C as standard.
If you wish to decrease the maximum temperature from 110 °C to 105 °C, perform
the following steps:
1. Open the technician menu (see 28).
2. Turn the top knob to the temperature symbol (position A – see point 9.2 on
page 33).
► The temperature symbol flashes.
► In the top display, "SEnB" appears.
3. Press the bottom knob once or twice until "t HI" appears in the top display.
► In the bottom display, "110" appears.
4. Turn the bottom knob to the left.
► In the bottom display, "105" appears.
► The maximum temperature was decreased from 110 °C to 105 °C.
Setting the parameters of the PI controller
The time constant of the PI controller (I-component) is set to 350 as standard.
If you wish to change this value, perform the following steps:
1. Open the technician menu (see 28).
2. Turn the bottom knob to the temperature symbol (position A – see point 9.2
on page 33).
► The temperature symbol flashes.
► In the top display, "SEnB" appears.
WORLD OF WELLNESS
p. 30/52