Status Output; Settings In The Technician Menu - Sentiotec Pro C3 Instructions D'installation Et D'utilisation

Installation instructions, only for experts

Status output

The function selection switch 7 can be used to help to decide whether the sta-
tus output should be activated during sauna mode or during the post-drying
programme. Activation during the post-drying programme allows the evaporator
to be drained automatically when a combi heater with an auto refill function is
being used.
● The function selection switch 7 is set to the OFF position as standard. The sta-
tus output is therefore activated during sauna mode.
● If you wish to activate the status output for the post-drying mode, place the
function selection switch 7 in the ON position.
Setting the operating mode for the additional output
The additional output can either be regulated or switched on and off. The dimmer
switch function is activated or deactivated using the function selection switch 8.
● The function selection switch 8 is set to the ON position as standard. The dim-
mer switch function is therefore activated.
● If you wish to deactivate the dimmer switch for the additional output, place
the function selection switch 8 in the OFF position.
8.2.

Settings in the technician menu

Opening the technician menu
Additional settings can be made in the technician menu. To access the technician
menu, perform the following steps:
1. Switch off the sauna control unit.
2. Press the bottom knob and the ON/OFF switch at the same time.
► In the top display, "SEtt" appears briefly.
► The two knobs flash.
You do NOT have to confirm the settings in the technician menu. The set-
tings are saved automatically as soon as you close the technician menu
(see page 32).
WORLD OF WELLNESS
p. 28/52