Sentiotec Pro C3 Instructions D'installation Et D'utilisation page 79

Installation instructions, only for experts
Activating/deactivating phase alignment
Phase alignment is activated or deactivated using the function selection switch 3.
● The function selection switch 3 is set to the ON position as standard. Phase
alignment is therefore activated.
● If you wish to deactivate phase alignment, place the function selection switch
3 in the OFF position.
Activating/deactivating the remote start and preset time function
The remote start and preset time functions are activated or deactivated using
the function selection switch 4. The remote start and preset time functions can
only be activated and deactivated together.
● The function selection switch 4 is set to the ON position as standard. The re-
mote start and preset time functions are then activated.
● If you wish to deactivate the remote start and preset time functions, place the
function selection switch 4 in the OFF position.
Setting the light operating mode
!
EN 60335-2-53 states that sauna control units with a remote start and
preset time function may only be used with sauna heaters which satisfy
the combustion test described in paragraph 19.101 of EN 60335-2-53.
Alternatively, a suitable safety shut-off device can be installed in or
above the heater. Observe the information in the operating instructions
for your sauna heater.
The light for the sauna room can either be dimmed or switched on and off.
The dimmer switch function is activated or deactivated using the function selec-
tion switch 5.
● The function selection switch 5 is set to the ON position as standard. The dim-
mer switch function is therefore activated.
● If you wish to deactivate the dimmer function for the sauna room light, place
the function selection switch 5 in the OFF position.
WORLD OF WELLNESS
p. 27/52
En