Getting To Grips With The Generating Set; Initial Commissioning; Using The Generating Set - SDMO INVERTER PRO 2000 Manuel D'utilisation Et D'entretien

3 Getting to grips with the generating set

3.1 Key to illustrations
The cover illustrations can be used to identify the various components of the power take-off alternator. The procedures in the
manual refer to these illustrations using letters and numbers as identifiers, for example, (A1) refers to the number 1 on figure A.
Earth terminal
Oil filler cap
Fuel level indicator
Fuel tank cap
Air vent
Fuel tap button
Screen filter
Air filter
Choke
Correct oil level
Air filter cover screw
Air filter cover
Foam element
Exhaust silencer cover
screw
Exhaust silencer cover
3.2

Initial commissioning

On taking delivery and commissioning the generating set:
1. Check that it is complete and not damaged in any way.
2. If the generating set is equipped with a transport bracket located on the engine, remove it.
3. Check the oil and fuel levels and top them up if necessary.
4. If applicable, connect the battery.
Never invert the positive and negative terminals on the battery when connecting it, as this could cause serious damage to
the electrical equipment.
Some generating sets require a running in period. Contact your nearest agent for more information.

4 Using the generating set

4.1 Positioning the generating set for operation
The generating sets are intended to operate while stationary. They may not be installed on a vehicle or other
mobile equipment unless a study has been carried out analysing the various usage specifications.
IMPORTANT
1. Choose a site that is clean, well ventilated and sheltered from bad weather.
2. Position the generating set on a flat horizontal surface that has sufficient load-bearing capacity to prevent it from sinking.
3. Check that the angle of the generating set, in all directions, does not exceed 10°.
4.2 Check the generating set is in a good general condition (bolts, hoses)
Inspect the entire generating set before start-up and after each use to prevent any faults or damage.
1. Check that the generating set is clean, particularly around the air intake zones.
2. Check all the pipes and hoses to ensure they are in good condition and that there are no leaks.
Pipes or hoses must be replaced by a specialist technician. Please contact your nearest agent.
3. Tighten any loose bolts.
The cylinder head bolts must be retightened by a specialist technician. Please contact your nearest agent.
A1 Switch
Economic idle speed
A2-B1
(Hare-Tortoise)
A3 Starter-recoil reel
Electric socket
A4
(alternating current)
12 V socket (direct
A5
current)
Circuit breaker for 12V
A6
socket
Operating light
A7-C1
(alternating current)
A8 Oil safety light
A9 Overload warning light
B2
D1
D2
D3
Exhaust silencer grille
F1
screw
F2 Exhaust silencer grille
Parallel operating
A10
terminals
A11 Spark plug
A12 Exhaust silencer
A13 Side enclosure
A14 Side enclosure screw
A15 Oil level access flap
A16 Transport handle
A17
A18
Fuel drain pipe
Fuel drain screw
Spark plug access cover
Spark plug cap
F3 Spark arrester
F4
A19
A20-E3
A21
A22
A23
A24
A25
C2
C3
E1
E2
F5