Factory Settings Of The Positioner; Installation; Safety Instructions - Burkert 8694 Guide Rapide

6.8. factory settings of the positioner
Functions can be activated via DIP switches:
function parameter
CUTOFF Sealing function below
Sealing function above
CHARACT Select characteristic
DIR.CMD Effective direction set-point
value
Tab. 1: Factory settings - Functions
Additional functions are described in the operating instruc-
tions Type 8694 and in the communication software.
These instructions can be found on the Internet at
www.burkert.com.
without change to the settings via the communications software a linear
1)
characteristic is stored in FREE.
Type 8694

Installation

Value
2 %
98 %
FREE
1)
rise
7. insTallaTion
Only for positioner without pre-assembled process valve.
7.1. safety instructions
Danger!
risk of injury from high pressure!
• Before dismounting pneumatic lines and valves, turn off the
pressure and vent the lines.
risk of electric shock!
• Before reaching into the device or the equipment, switch off the
power supply and secure to prevent reactivation!
• Observe applicable accident prevention and safety regulations
for electrical equipment!
Warning!
risk of injury from improper installation!
• Installation may be carried out by authorized technicians only
and with the appropriate tools!
risk of injury from unintentional activation of the system and
an uncontrolled restart!
• Secure system from unintentional activation.
• Following assembly, ensure a controlled restart.
english
11