How To Replace And Adjust Some Elements - Euromax 9523PBH Instructions Pour L'installation, L'utilisation Et La Maintenance

2.7 How to replace and adjust some elements

WARNING!
Elements replacement and adjustment work is classed as non-routine
maintenance, meaning it must be carried out by an authorized installer.
Before starting any repair or maintenance work, you must switch off the appliance
at the main power source in order to avoid any electrical contacts.
Close the water supply taps too.
Remember to restore and put back the seals, sealants and sheathing inserted,
before finishing the work.
Thermostat replacement
Thermostat bulbs are located in the cooking chamber,
on the left, behind the pans supports:
• open the oven left side panel;
• unscrew, if presents, the stuffing box
the thermostat wires, remove the wires and unscrew
the holding of the security thermostat and the screws
of the cooking thermostat which can be find behind
the control panel;
• put the bulbs back in place making sure the capillary
wires in the cooking chamber are at least 3 cm long,
re-establish the electrical connections.
Door seal
The seal is press-fitted, therefore it must be removed by pulling it and refitted by pressing in again
(Fig.9) .
This operation must be
In order not to damage the seal.
(A-Fig.8)
carried out by hand
Fig. 9
of
A
37
GB
Fig. 8