Pioneer XR-MR7 Mode D'emploi page 121

Troubleshooting
Symptom
Any No sound
function
CD No playback
when 6 is
changer
pressed, or disc
is ejected.
No sound
When CD tray is
closed, it opens
again.
"E1" message
appears.
"E2" message
appears.
Radio Broadcasts can't
Broadcasts be heard, or are
heard indistinctly.
Stereo
broadcasts are
heard in
monaural.
Other Timer doesn't
operate
Remote control
unit doesn't
operate
¶ Installing the unit near a television set may cause some disruption in the television image, particularly when using an indoor television antenna. In this
event, install an outdoor antenna or move the unit farther away from the television.
¶ Static electricity and other external influences may cause the unit to malfunction. In this event, temporarily disconnecting the power cord and
reconnecting it should rectify the problem.
Digital synchro recording troubleshooting
If digital synchro-recording fails to operate correctly, check the following:
• Pause playback of the source, and set the digital synchro recording function again.
• If you're recording from a portable CD player, etc., make sure that the shock-protection feature is switched off.
• Start playback of the source component once you see the "SYNC" indicator start to blink.
• If none of the above solves the problem, use manual digital recording to record.
Digital synchro-recording uses a digital sub-signal contained in the source player' s digital output. Some CD/MD/DAT/DVD players are not compatible with
synchro recording.
All manuals and user guides at all-guides.com
Source of Problem
Power plug is disconnected.
Cord or cords not connected correctly.
Source function not selected correctly.
Disc is loaded upside down.
Disc is dirty or cloudy.
Disc has large scratch/warp.
Input selector not set for CD.
CD is set for pause mode.
Disc is loaded incorrectly.
2 or more discs have been loaded on
top of each other.
Disc is loaded incorrectly.
Mechanical error
Antennas are not connected.
Antenna placement or direction is
wrong.
Another electrical appliance (fluorescent
lamp, hair dryer, etc.) is being used.
"MONO" indicator is lighted.
Clock isn't set to current time.
Batteries are exhausted.
A fluorescent lamp is too close to the
unit's remote control unit signal receiver.
Remedy
Connect power plug correctly.
Connect all cords properly (p. 7-15).
Select playback function desired.
Load discs correctly, with label side up.
Clean disc (p.47-48).
Replace disc.
Press 6.
Load discs correctly (p.30).
Remove discs and reload only one disc per tray.
Load discs correctly (p.30).
Clean disc and tray (p.47-48).
Make sure that there is nothing obstructing the disc
tray.
Connect antennas correctly (p.10-11).
Try adjusting antenna placement or direction.
Discontinue use of interfering appliance.
Press remote control unit's MONO button so that
"MONO" indicator goes out (p.26).
Set clock to correct current time (p.22-23).
Replace batteries in remote control unit (p.19).
Place lamp farther from remote control unit signal
receiver.
121
En