Abicor Binzel iSTM Mode D'emploi page 35

iSTM
6.3 Attaching the ABIROB
1
®
1 ABIROB A torch neck
2 Allen key
Abb. 6 Attaching the ABIROB
®
A torch neck
2
3 Lock ring
4 iSTM fastener
®
A torch neck
1 Equip the ABIROB
gas nozzle.
®
2 Insert the ABIROB
into the iSTM (4).
3 Tighten the set screws (5) using an Allen key (2). Tightening torque
M= 2.5 Nm.
4 Close the lock ring (3) by rotating it to the left.
NOTE
The welding torch is equipped with a contact tip for a wire diameter of 1 mm
and a gas nozzle NW16. If you need a different equipment, please order it
separately.
 see the spare parts list in the appendix
3
5
®
A torch neck (1) with a tip adaptor, contact tip and
A torch neck (1) via the guide grooves until the stop
6 Putting into operation
4
5
2 set screws
EN - 13