Abicor Binzel iSTM Mode D'emploi page 33

iSTM
6.2.2 Mounting the cable assembly on the robot
1
11
10
1 Cable setting tool
2 Lock ring
3 Robot
4 Cable assembly connection
Abb. 5 Attaching the cable assembly
Make sure that the cable assembly can still be moved
and downwards after fastening the wire feeder.
NOTE
• When replacing the liquid-cooled ABIROB
sure that any coolant residues are removed from the iSTM ABIROB
• When mounting liquid-cooled ABIROB
sure that the water nipples in the ABIROB
are inserted correctly into the cable assembly adapter. Observe the
forced positioning.
• After mounting is complete, check for any leaks.
2 3
9
5 Cable assembly
6 Clamp
7 2 cylinder screws M6x25
8 Positioning pin
6 Putting into operation
®
W cable assemblies, make
®
W cable assemblies, make
®
W welding torch interface
4
7
9 Welding torch interface
10 Disc
11 Fastening screw
±
20 mm upwards
®
W.
5
6
8 7
EN - 11