Install The Brushes - Nilfisk SC6500 Mode D'emploi

A - ENGLISH
INSTALL THE BRUSHES (DISC SYSTEM)
CAUTION!
Turn the key switch off (O) and remove the key, before changing the brushes, and before opening any access panels.
1 Make sure the Scrub Deck is in the RAISED position. Make sure the Key Switch (A) is off (O).
2 See Figure 2. Remove both side skirt assemblies. NOTE: The skirts are held in place by two large Knobs (AA). Loosen these knobs and slide the Skirt
Assemblies (BB) off of the Scrub Deck.
3 To mount the Brushes (CC) (or pad holders) align the Lugs (DD) on the brush with the holes on the mounting plate and turn to lock in place (turn the outside
edge of brush towards the front of machine as shown (EE)).
2
FIGURE
A - 10
INSTRUCTIONS FOR USE
1100D
EE
1300D
EE
EE
SC6500 - 56091145
AA
BB
DD
CC
EE
AA
DD
CC
EE
BB
12/2014