Install The Brushes - Nilfisk Hydro-Retriever 3200 BR 850 Mode D'emploi

Table des Matières

Les langues disponibles

INSTALL THE BRUSHES (DISC SYSTEM)

Make sure the Key Switch (33) is off (O). To access the brush mounting plates, remove both the left and right outer side skirt assemblies from the Scrub

Brush Deck (13). Note: The skirts are held in place by two black knobs on each skirt, to separate, loosen knob(s) and pull skirt straight out.

To mount the brushes (or pad holders) align the lugs on the brush with the holes on the mounting plate and turn to lock in place (turn outside edge of brush

towards front of machine).

56505781 - Magna Grit 46

56505782 - Dyna Grit 80

56505788 - MidLite Grit 180

56505787 - MidGrit 240

56505783 - AgLite Grit 500

56505784 – Prolene

56505785 - ProLite

56505786 - Union Mix

DISC BRUSH APPLICATION GUIDE (SUGGESTION ONLY)

Application

Stripping:

Concrete

Terrazo

Ceramic/Quarry tile

Vinyl tile

General Scrubbing:

Concrete

Terrazo

Ceramic/Quarry tile

Marble

Vinyl tile

Raised-rubber tile

Polishing:

Raised Disc Tile

Marble

Vinyl tile

INSTALL THE BRUSHES (CYLINDRICAL SYSTEM)

Make sure the Key Switch (33) is off (O). To access the brushes, swing both side skirt assemblies open. Note: The skirts are held in place by a large

cotter pin on each side, remove the pins and swing the skirt assemblies out of the way. Loosen the black knobs (one on each side) on top of the idler

assemblies and remove the idler assemblies. Slide the brush into the housing, lift slightly, push and turn until it seats. Re-install the idler assemblies,

close the skirt assemblies and secure with cotter pins.

56407475 – Polypropylene, 32"

56407473 - Soft Nylon, 32"

56407474 - Stiff Nylon, 32"

56407476 - 180 Grit, 32"

56407477 - 80 Grit, 32"

56407478 - 46 Grit, 32"

CYLINDRICAL BRUSH APPLICATION GUIDE (SUGGESTION ONLY)

Application

Stripping:

Concrete

Terrazo