Table Of Scheduled Operations; Troubleshooting; Wiring Diagram List - Mase Generators MPL 10 SX Manuel D'instructions Et D'entretien

GENERATORS

6.7 Table of scheduled operations

OPERATION
Check the level of the oil in the sump
Check belt tension
Clean the air filter
Replace the oil sump
Check the level of the electrolytes
and thebattery charger status
Replace the fuel filter
Replace the oil filter
Replace the alternator belt
Regulate the play in the rocker lever
Check the injectors
Calibrate and clean the injectors
Check alternator bushes
Partial overhaul
General overhaul

6.8 Troubleshooting

The starter motor turns but the main engine does not
cut in.
- Make certain there is fuel in the tank (refill).
- Make certain that the Stop solenoid valve is powered
(contact the Service Centre)
- Make certain that the fuel pump is functioning (contact
the Service Centre)
The control panel does not cut in when the ignition
key is turned.
- Check the protection fuse (replace)
- Check the connection cable and electrical connectors
(reconnect)
- Make certain that the battery is operative (recharge or
replace)
The unit cuts out during operation.
- Check whether the protection has been activated and
the warning light is on (remove the cause and try to start
up again)
- Make certain there is fuel in the tank (refill)
The engine is running irregularly.
- Check the fuel filters (replace)
- Make certain that the fuel pump is operating properly
(replace)
- Check calibration of the injectors (contact an Author-
ized Service Centre)
UK
WIRING DIAGRAM LIST MPL 10- 15 SX- CX (M)
1 Socket 3 p + n + e 32A
HOURS
2 Socket 2 p + e 16 A
10
3 Output terminal
50
4 Circuit breaker - earth fault device
100
5 Commutator
150
6 Voltmeter
7 Frequency meter
150
8 Hour counter
300
9 Ampermeter
300
10 Stator
500
11 Rotor
600
12 Diode bridge
600
13 Starter
600
14 Starting key
1200
15 Cutout module
2500
16 Connector
5000
17 Emergency stop button
18 Oil pressure indicator
19 Air thermostat
20 Fuel float
21 Solenoid valve
22 DC alternator
23 Battery
WIRING DIAGRAM LIST MPL 10-15 SX- CX (NSM)
1 Socket 3 p + n + e 32A
2 Socket 2 p + e 16 A
3 Output terminal
4 Circuit breaker - earth fault device
5 Commutator
6 Voltmeter
7 Frequency meter
8 Hour counter
9 Ampermeter
10 Stator
11 Rotor
12 Diode bridge
13 Starter
14 Starting key
15 Cutout module
16 Connector
17 Emergency stop button
18 Oil pressure indicator
19 Air thermostat
20 Fuel float
21 Solenoid valve
22 DC alternator
23 Battery
24 Automatic Voltage Regulator
- 26 -
MPL SX - CX