Starting And Stopping - Worx WG781 Manuel D'instructions

adjusting height. The blades will continue
to rotate after the machine is switched
off, a rotating blade can cause injury.
CaUTioN: do not touch rotating blade.
For the first cutting of the season, a high
cutting adjustment should be selected.
The lawnmower can be set to 6 cutting heights
between 1.5" (38mm) and 3.5" (88mm)..
For this purpose, move the cutting height
adjustment lever outwards then choose to
the preferred position. Each position will raise
or lower the mower to the desired height.
OPERATION

1. STarTiNg aNd SToPPiNg

(See i1, i2,i3)
warNiNg! The blade will continue
to rotate for a few seconds after the
machine is switched off. Allow the motor/
blade to stop rotating before switching "on"
again. Do not rapidly switch off and on.
STarTiNg:
warNiNg! The battery is
disconnected from your lawn
mower and you must insert the connector
into the battery socket before use.
1) Insert safety key into the housing
of the switch box. (See I2)
2) Slide the key to the right and
hold in position. (See I3)
3) Pull the lever bar towards the handle
and the mower will start. (See I3)
4) Release the safety key.
SToPPiNg
Release the switch lever. Mower
will automatically turn OFF .
2. baTTEry STaTUS lEd'S (See j)
NoTE: battery Status lEd's are
not active in charging mode. The
Status lEd's will indicate the
battery condition when the button
on the battery is pressed.
The LED's constantly senses and displays
the battery condition as follows:
Press the button "POWERTEST" ,
3-in-1 cordless lawn mower
the light button is illuminated.
When the three green lights are illuminated,
the battery is in a highly charged condition.
When two lights (
battery is in a moderately charged condition.
When only one green light (
illuminated, the battery charge is depleted.
Before using your new mower for the
first time, it is recommended that the
unit be charged overnight to ensure
that the battery is fully charged.
imPorTaNT
when only one light is illuminated,
your battery is overly discharged, even
though the mower may still be capable
of cutting grass. Continuing to operate
your lawnmower with the battery in this
discharged condition may reduce the
life and performance of your battery.
3. rEmoviNg mUlChiNg PlUg (See k1)
To remove the mulching plug (16) so
that you can bag the grass or discharge
with the optional discharge chute,
follow the steps listed below:
1) Shut the mower off, wait until the blade
stops and remove the safety key.
2) Raise the safety guard and hold it up.
3) Grasp the middle of the plug, lift and
pull out the mulching plug completely.
4) The safety guard is spring loaded.
When you release it, the guard will
return to the closed position.
4. iNSTalliNg mUlChiNg PlUg (See k2)
1) Turn the mower off, wait until the blade
stops and remove the safety key.
2) Raise the safety guard and hold it up.
3) Slide the mulching plug (16) into
the discharge opening until it is
firmly in contact with the deck.
4) Release safety guard and ensure
it is properly closed.
5. iNSTalliNg SidE-diSChargE
ChUTE (See l & m)
Using the mulching plug and side-
discharge chute (17), the grass can be
discharged from the side of the machine.
To assemble the side-discharge insert, raise
) are illuminated, the
) is
EN
15 15