Assembly And Operation - Worx WG743 Mode D'emploi

OPERATION INSTRUCTION
NOTE: : To reduce the risk of injury,
user must read instruction manual
Intended Use
This product is intended for domestic lawn
mowing.

ASSEMBLY AND OPERATION

ACTION
ASSEMBLY
Assembling the handle bar
NOTE: Choose one of the two
holes in the lower handle for
desired handle's height.
Assembling grass collection bag
Fitting grass collection bag to
the lawn mower
NOTE: Depress the grass
collection bag slightly to ensure
that it is completely installed.
NOTE: Take the mulching insert
out of the lawn mower before
fitting the grass collection bag.
Checking the battery charge
condition
NOTE: Fig. D1 only applies for
the battery pack with battery
indicator light.
Charging the battery pack
NOTE: The batteries are shipped
uncharged. Each battery must be
fully charged before the first mow.
Always fully charge the two
batteries at same time. More
details can be found in charger's
manual.
Cordless Lawn Mower
Fitting/removing battery
NOTE: This machine will only
run when 2 batteries are
installed. It is recommended
to use the same two batteries
and charge the two batteries
at the same time.
Using two different sized
batteries or if one battery
isn't fully charged then the
machine will only run to the
lowest common denominator.
FIGURE
OPERATION
Battery power indicator on the
See Fig. A1,
machine
A2, A3, A4,
See details in BATTERY STATUS
A5
part
IMPORTANT
See Fig. B1,
When only one light is illuminated,
B2, B3, B4
at least one battery is depleted and
needs to be charged, even though
the mower may still be capable
of cutting grass. Continuing to
See Fig. C1,
operate your lawnmower with
C2, C3
the battery in this discharged
condition may reduce the life and
performance of your battery.
When no light is illuminated,
at least one battery is not fully
installed or battery may be
See Fig. D1
defective, please double check
the batteries are fully seated into
position.
Starting & stopping
Selecting the INTELLICUT DIAL
See Fig. D2
ECO MODE
Set the Intellicut Dial to ECO
mode when mowing in
everyday conditions, removing
approximately 1 inch of grass at
a time.
TURBO MODE
Set the Intellicut Dial to POWER
mode when cutting dense or
overgrown grass.
Adjusting the Cutting Height
See Fig. E
See Fig. F
17
See Fig. G1,
G2
See Fig.
H1,H2
See Fig. I
EN