Assembly & Operation - Worx WG770 Mode D'emploi

ASSEMBLY & OPERATION
ACTION
ASSEMBLY
Assembling the handle bar
Adjustment handle's height
Assembling the grass
collection bag
Assembling the grass
collection bag to the lawn
mower
Removing/emptying the grass
collection bag
Removing the battery pack
NOTE: The battery pack
is shipped uncharged. The
battery must be fully charged
before the first mow.
Checking the battery charge
condition
16
Charging the battery pack
More details can be found in
WA3724's manual
Installing mulching plug
OPERATION
Starting
Stopping
Adjusting The Cutting Height
Cleaning The Mower
WARNING: Plug the hose on
the Washout port first, then
start the mower.
STORAGE
NOTE: Removing the battery
pack
36V Lead-acid Lawn Mower
MULCHING MOWING TIPS
When using the mulching plug, your new
FIGURE
mower is designed to cut the grass clippings
into small pieces and distribute them back into
the lawn, using mulching fins located inside
See Fig. A1
the mower deck.
Under normal conditions, the mulched grass
See Fig. A2
will biodegrade quickly to provide nutrients
to the lawn. Please review the following
See Fig. B
recommendations for optimum mulching
performance,
1) Avoid mowing when the grass is wet from
See Fig. C1
C2 C3
See Fig. C4
2) For best mulching performance, set the
See Fig. D1 D2
See Fig. E1
See Fig. E2
See Fig. F1 F2
3) For best performance, keep the mower
See Fig. G1 G2
See Fig. G3
See Fig. H
See Fig. I
4) Certain types of grass or grass conditions
See Fig J1 J2
5) Change your cutting pattern from week to
rain or dew. Wet grass may form clumps
which interfere with the mulching action
and reduce runtime. The best time to mow
grass is in the late afternoon when the
grass is dry and the newly cut area will not
be exposed to direct sunlight.
cutting height to remove about one third
of the grass blade length, ideally no more
than 1.5" inches at one time. If the lawn is
overgrown, it may be necessary to increase
the cut height to reduce the pushing effort and
prevent overloading the motor. For extremely
heavy mulching, it is advisable to first cut at a
high cut height setting, and then re-cut to the
final cut height. Otherwise, make narrower
cuts and mow slowly.
housing free of built-up grass. From time to
time turn off mower and wait for the blade
to come to a complete stop. Then unplug
the Safety Key(6) and turn mower on its
side. Using an object such as a stick, wipe
out any accumulation of grass in the blade
area. Be careful of the sharp edges of the
blade. Clean often in wet, new grass, and
always after every use.
may require that an area be mulched a
second time to fully disperse the grass
throughout the lawn. If cutting a second
time, it is advisable to cut perpendicular
(across) the first cut pattern. DO NOT
CHANGE CUT PATTERN IN ANY WAY THAT
WOULD CAUSE MOWING DOWN A HILL.
week. This will help prevent matting and
graining of the lawn.
EN