Assembly & Operation - Worx NITRO Mode D'emploi

P1
ASSEMBLY & OPERATION
NOTE: Read instruction handbook before operation this
machine.
INTENDED USE
This product is intended for domestic lawn mowing
ASSEMBLY & OPERATION
ACTION
ASSEMBLY
Assembling the handle bar & Adjusting
Handle's height
NOTE: Press and hold Quick-release
button during operation.
Assembling the grass collection bag
Assembling the grass collection bag to
the lawn mower
NOTE: Depress the grass collection bag
slightly to ensure that it is com-pletely
installed.
NOTE: Push the mulching-bag switch
lever to open the mulching outlet before
fitting the grass collection bag.
Removing/emptying grass collection bag
WARNING! Always check the
safety flap close the discharge
outlet before using. Never lift the safety
flap when the lawn mower is being used
without fitted grass collection bag.
Cordless Lawn Mower
23
21 22
FIGURE
See Fig. A1, A2
See Fig. B
See Fig. C1,
C2, C3
See Fig. D1, D2
O-3
P2
Assembling the side-discharge chute
Lift the mulching door to assemble the
side-discharge chute.
Note: Remember to remove the grass
collection bag firstly and then push the
mulching-bag switch lever to close the
mulching outlet before assembly.
Removing /fitting the battery pack
NOTE: This machine will only run
when sp - batteries are installed. It is
recommended to use the same AH
batteries and charge the two batteries at
the same time.
When you use two batteries with different
AH, the machine will only run to the lower
common denominator.
Checking the battery charge condition
NOTE: Fig.G1 only applies for the battery
pack with battery indicator light.
Charging the battery pack
NOTE: The batteries are shipped
uncharged. Each battery must be fully
charged before the first mow.
Always fully charge the two batteries at
same time. More details can be found in
charger's manual.
OPERATION
See Fig. E1, E2
See Fig. F1,F2
13
See Fig. G1
See Fig.G2
EN