Assembly & Operation; Turbo Mode - Worx WG772 Mode D'emploi

Remove the key
POSITEC Inc. has established
a partnership with the RBRC
Corporation to recycle any
Positec batteries with the
RBRC-call2recycle seal. For
environmental protection, please
do not discard batteries in the
trash. After the batteries' life
cycle is ended, then please call
1.800-822-8837 for a free service
that will properly dispose of the
battery
3-in-1 Cordless Lawn Mower
ASSEMBLY & OPERATION
Action
ASSEMBLY
Assembling the handle bar
Adjustment handle's height
Assembling the grass
collection bag
Assembling the grass
collection bag to the lawn
mower
Removing/emptying the grass
collection bag
Installing side-discharge chute See Fig.D1,D2
Installing mulching plug
Removing /fitting the battery
pack
NOTE: The Battery Pack is
shipped uncharged. The
Battery must be fully charged
before the first mow.
Checking the battery charge
condition
Charging the battery pack
More details can be found in
WA3859's manual
OPERATION
Starting
Stopping
Selecting the work mode dial
ECO MODE
Set the IntelliCut Dial (3) to
ECO mode when mowing
in everyday conditions,
removing approximately 1
inch of grass at a time.

TURBO MODE

Set the IntelliCut Dial to
POWER mode when cutting
dense or overgrown grass.
Adjusting The Cutting Height See Fig. J
Figure
See Fig. A1
See Fig. A2
See Fig. B
See Fig. C1,
C2, C3
See Fig. C4
See Fig.E
See Fig. F1,F2
15
See Fig. G1
See Fig. G2
See Fig. H1,H2
See Fig. H3
See Fig. I
EN