Worx WG772 Mode D'emploi page 19

Tondeuse à gazon sans fil 3 en 1
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. Mower runs but
cutting performance is
unsatisfactory, or does not
cut entire lawn.
4. Mower is too hard to
push.
5. Mower is abnormally
noisy and vibrates.
6. Battery charger LED's
not on.
7. Battery charger LED
does not flip to green.
8. Mower not picking up
18
clippings with the Grass
Collection Bag.
9. When mulching there
are clippings visible.
10. Low or diminished
run-time after many uses
3-in-1 Cordless Lawn Mower
A. Has battery been fully charged? Plug in charger and wait for
green light to come on. "
B. Release switch lever to turn mower off. Remove safety key.
Turn mower over and check: Blade for sharpness - Keep blade
sharp. Deck and discharge chute for clogging.
C. Wheel height adjustment may be set too low for grass
condition. Raise cutting height
A. Raise cutting height to reduce deck drag on grass. Check
each wheel for free rotation.
A. Release switch lever to turn mower off. Remove safety
key. Turn mower on side and check blade to ensure it has not
been bent or damaged. If blade is damaged, replace with a
replacement blade. If the underside of the deck is damaged
return mower to an Authorized service center.
B. If there is no visible damage to the blade and the mower still
vibrates: Release switch lever to turn mower off, remove safety
key and remove blade. Rotate blade 180 degrees and retighten.
If mower still vibrates, return the mower to an authorized
service center.
A. Check plug connection.
B. Replace charger.
A. Battery needs to be diagnosed. Take to authorized service
center.
A. Remove mulch plate when bagging.
B. Chute clogged. Release switch lever to turn mower off.
Remove safety key. Clear chute of grass clippings.
C. Too much cut grass. Raise cutting height of wheels to shorten
length of the cut.
D. Bag full. Empty bag more often.
A. Too much cut grass. Raise cutting height of wheels to shorten
length of the cut. Do not cut off more than 1/3 of total length.
B. Check blade for sharpness. Always keep blade sharp.
A. Return to Authorized Service location - may need new
battery.
EN

Publicité

Table des Matières
loading

Table des Matières