Worx WG772 Mode D'emploi page 18

NOTE:
1. Be sure the mower is turned off and
remove the key.
2. Place the mower in stand up storage mode.
BLADE BALANCING (See Fig. N)
Check balance of blade by placing center
hole in blade N-1 over a nail or screwdriver
shank N-2, clamped horizontally in a vise N-3.
If either end of the blade rotates downward,
file that end. Blade is properly balanced when
neither end drop
BLADE MAINTENANCE (See Fig. O1, O2)
Replace your metal Blade (14) after 50 hours
mowing or 2 years, which ever is the sooner-
regardless of condition.
Follow these procedures to remove and
replace the Blade. You will need garden
gloves (not provided) and a spanner wrench
(not provided) to remove the Blade. Hold the
Blade and unscrew the Blade Bolt (13)
counter-clockwise using a spanner wrench,
TROUBLE SHOOTING
Problem
1. Mower doesn't run
when switch lever is
activated.
2. Motor stops while
mowing.
3-in-1 Cordless Lawn Mower
and then remove the Blade.
To re-assemble, position the Blade with the
cutting edges towards the ground. Then
securely tighten the Blade Bolt.
STORAGE:(See Fig. L1, L2)
Stop the mower and always remove the
Safety Key. Clean the exterior of the machine
thoroughly using a soft brush and cloth. Do
not use water, solvents or polishes. Remove
all grass and debris, especially from the
ventilation slots.
Turn the machine on its side and clean the
blade area. If grass cuttings are compacted
in the blade area, remove with a wooden or
plastic implement.
Store the machine in a dry place. Do not place
other objects on top of the machine.
To aid storage, release the Handle knobs (8),
and rotate or fold the Upper Handle.
A. Check to make sure safety key has been installed and is fully
seated and that button on switch housing is being completely
pushed.
B. Release switch lever to turn mower off. Remove safety key,
turn mower over and check that blade is free to turn. If not free,
return to an authorized servicer. Blade should turn freely.
C. Has battery been fully charged? Plug in charger and wait for
green light to come on.
A. Release switch lever to turn mower off. Remove safety key,
turn mower over and check that blade is free to turn. If not free,
return to an authorized servicer. Blade should turn freely.
B. Raise cutting height of wheels to highest position and start
mower.
C. Has battery been fully charged? Plug in charger and wait for
green light to come on.
D. Avoid overloading the mower. Slow down the cutting pace by
pushing mower slower or raise the cut height. Or both.
Solution
17
EN