Worx WG781 Manuel D'instructions page 16

the side-discharge cover (8) and hold it up,
position the side-discharge chute (17) onto
the hooks, then release the cover to lock
the side-discharge insert into position.
6. mowiNg TiPS
NoTE: always inspect area where
mower is to be used and remove
all stones, sticks, wire, metal
and other debris which might be
thrown by the rotating blade.
1) Mow across the face of slopes, never
up-and-down. Exercise extreme caution
when changing direction on slopes. Do
not mow excessively steep slopes. Always
maintain good footing and balance.
2) Release switch lever to turn the mower
"OFF" when crossing any graveled area
(stones can be thrown by the blade).
3) Set mower at highest cutting height
when mowing on rough ground or
in tall weeds. Removing too much
grass at one time can cause circuit
breaker to trip, which stops mower.
4) If a grass bag is used during the fast
16 16
growing season, the grass may tend to
clog up at the discharge opening. Release
switch lever to turn mower "OFF" and
remove the safety key. Remove the grass
bag and shake the grass down to the back
end of the bag. Also clean out any grass
or debris which may be packed around the
discharge opening. Replace the grass bag.
5) If mower should start to vibrate
abnormally, release switch lever to
turn mower "OFF" and remove safety
key. Check immediately for cause of
vibration. Vibration is usually a warning
of trouble. Do not operate mower until
a service check has been made.
6) ALWAYS RELEASE SWITCH LEVER
TO TURN MOWER "OFF" AND
REMOVE SAFETY KEY WHEN
LEAVING IT UNATTENDED EVEN FOR
ANY SHORT PERIOD OF TIME.
7. mUlChiNg mowiNg TiPS
While mulching, your new mower is
designed to cut the grass clippings into
small pieces and distribute them back into
3-in-1 cordless lawn mower
the lawn. Under normal conditions, the
mulched grass will biodegrade quickly
to provide nutrients to the lawn.
Please review the following recommendations
for optimum mulching performance.
1) Avoid mowing when the grass is
wet from rain or dew. Wet grass may
form clumps which interfere with the
mulching action and reduce runtime.
The best time to mow grass is in
the late afternoon when the grass is
dry and the newly cut area will not
be exposed to direct sunlight.
2) For best mulching performance, set
the cutting height to remove about one
third of the grass blade length, ideally
no more than 1.5 inch at one time.
If the lawn is overgrown, it may be
necessary to increase the cut height to
reduce the pushing effort and prevent
overloading the motor. For extremely
heavy mulching, it is advisable to first
cut at a high cut height setting, and then
re-cut to the final cut height. Otherwise,
make narrower cuts and mow slowly.
3) For best performance, keep the mower
housing free of built-up grass. From time
to time turn off mower and wait for the
blade to come to a complete stop. Then
unplug the safety key and turn mower on
its side. Using an object such as a stick,
wipe out any accumulation of grass in
the blade area. Be careful of the sharp
edges of the blade. Clean often in wet,
new grass, and always after every use.
4) Certain types of grass or grass
conditions may require that an area be
mulched a second time to fully disperse
the grass throughout the lawn.
If cutting a second time, it is advisable
to cut perpendicular (across) the
first cut pattern. DO NOT CHANGE
CUT PATTERN IN ANY WAY
THAT WOULD CAUSE
MOWING DOWN A HILL.
5) Change your cutting pattern from
week to week. This will help prevent
matting and graining of the lawn.
EN