Worx WG781 Manuel D'instructions page 18

solvents or polishes. Remove all grass and debris, especially from the ventilation slots.
Turn the machine on its side and clean the blade area. If grass cuttings are
compacted in the blade area, remove with a wooden or plastic implement.
Store the mower in a dry place. Do not place other objects on top of the mower.
To aid storage, press the handle height adjustment knob,
and rotate or fold the upper handle forward.
TROUBLE SHOOTING
ProblEm
1. Mower doesn't
run when switch
lever is activated.
2. Motor stops while
mowing.
18 18
3. Mower runs but
cutting performance
is unsatisfactory, or
does not cut entire
lawn.
4. Mower is too hard
to push.
5. Mower is abnor-
mally noisy and
vibrates.
6. Battery charger
LED's not on.
3-in-1 cordless lawn mower
A. Check to make sure safety key has been installed and is fully seated
and that button on switch housing is being completely pushed.
B. Release switch lever to turn mower off. Remove safety key, turn
mower over and check that blade is free to turn. If not free, return to an
authorized servicer. Blade should turn freely.
C. Has battery been fully charged? Plug in charger and wait for green
light to come on.
A. Release switch lever to turn mower off. Remove safety key, turn
mower over and check that blade is free to turn. If not free, return to an
authorized servicer. Blade should turn freely.
B. Raise cutting height of wheels to highest position and start mower.
C. Has battery been fully charged? Plug in charger and wait for green
light to come on.
D. Avoid overloading the mower. Slow down the cutting pace by push-
ing mower slower or raise the cut height. Or both.
A. Has battery been fully charged? Plug in charger and wait for green
light to come on. "
B. Release switch lever to turn mower off. Remove safety key. Turn
mower over and check: Blade for sharpness - Keep blade sharp. Deck
and discharge chute for clogging.
C. Wheel height adjustment may be set too low for grass condition.
Raise cutting height.
A. Raise cutting height to reduce deck drag on grass. Check each wheel
for free rotation.
A. Release switch lever to turn mower off. Remove safety key. Turn
mower on side and check blade to ensure it has not been bent or dam-
aged. If blade is damaged, replace with a replacement blade. If the
underside of the deck is damaged return mower to a Authorized service
center.
B. If there is no visible damage to the blade and the mower still vi-
brates: Release switch lever to turn mower off, remove safety key and
remove blade. Rotate blade 180 degrees and retighten. If mower still
vibrates, return the mower to an authorized service center.
A. Check plug connection.
B. Replace charger.
SolUTioN
EN