Renishaw MP11 Manuel D'installation Et D'utilisation page 17

STAGE 2 - ADJUSTMENT
1. Adjust on-centre position using
screws A indiviually backing them
off each time or by tapping the
probe baseplate with a soft
implement.
2. When the stylus tip runout is less
than 20µm, fully tighten screws B
6-8 Nm (4.4-5.9 lbf.ft) and repeat
step 1 until desired runout is
achieved (5µm possible).
If using screws A, use them in
opposition to move the probe,
at the same time progressively
tightening them as the final
setting is approached. Use two
hexagon keys if necessary.
3. It is important that all four screws
A are tight or tightened
1,5 - 3,5 Nm (1.1 - 2.6 lbf.ft),
once the final setting has been
achieved.
NOTE
IF AT ANY TIME THE UNIT IS
ACCIDENTLLY DROPPED, IT
SHOULD BE CHECKED FOR
ON-CENTRE POSITION.
STYLUS ON-CENTRE ADJUSTMENT
4mm AF
A
Probe
base plate
Shank
1-5
B
2,5mm AF