de
en
Water filter
A water filter can prevent scale buildup.
Before a new water filter is used, it must be
rinsed. To do this, proceed as follows:
1. Press the water filter firmly into the wa
ter tank with the aid of the measuring
spoon (19).
2. Fill the water tank (17) with water up to
the max mark.
3. Press and hold the
for at least three seconds. The menu
opens.
e
4. Press the
off /
edly until the display shows
filter
.
Activate filter
5. Select
rotary knob (15).
6. Press the start button (10).
7. Place a receptacle with a capacity of
0.5 litres under the outlet (6a).
8. Press the start button (10).
9. Water will now flow through the filter to
rinse it.
10. Empty the container.
The appliance is ready to use once more.
Note: Rinsing the filter simultaneously ac
tivates the setting for the
display.
The filter is no longer effective when the
Change filter!
the latest after 2 months. It needs to be
replaced for reasons of hygiene and so that
there is no buildup of limescale (this could
damage the appliance). Replacement filters
can be obtained from retailers (TZ70003) or
from customer service (467873). If no new
filter is used, turn the
No / Old
.
26
e
j
off /
button (13)
j
button (13) repeat
No / Old
with the upper
Change filter!
display appears, or at
filter
setting to
Note: You can use the filter indicator to
mark the month in which you inserted the
filter. You can also mark the month in which
you will need to replace the filter next (at
the latest after two months).
Note: If the appliance has not been used
for a prolonged period (e.g. vacation) the
filter should be rinsed before the appliance
is used again. To do so, dispense a cup of
hot water and pour it away.
Menu settings
You can adapt the appliance to your indi
vidual needs in the menu settings.
e
1. Hold the
off /
at least 3 seconds.
e
off /
2. Press the
ly until the required menu item appears
in the display.
3. Select the required setting with the
upper rotary knob (15).
4. Confirm by pressing the start button
(10).
To leave the menu without making any
changes, turn the rotary selector to
and press the start button (10).
j
button (13) down for
j
button (13) repeated
Exit