Water Filter; Frost Protection - Siemens TI353 Série Mode D'emploi

Water filter

~ Fig. '
W a t e r f i l t e r
A water filter lessens limescale deposits
and reduces impurities in the water. The
appliance also does not need to be
descaled so often. Water filters are
available from retailers or from
customer service.
If a water filter is inserted, the appliance
will show when this needs to be
changed. The display shows the
relevant prompt.The ) symbol will light
up.
Inserting or replacing a water filter
A new water filter must be rinsed before
it can be used.
The appliance is switched on. The water
tank has been filled.
Simultaneously hold down %
1.
and calc'nClean for at least
3 seconds.
Touch the "V" button cappuccino
2.
repeatedly until "W. hardness"
appears.
Confirm by pressing the "ok" button
3.
latte macchiato.
Press the "V" button cappuccino
4.
repeatedly until "Water filter"
appears.
Confirm by pressing the "ok" button
5.
latte macchiato.
The display shows "Filter act.".
Immerse the water filter (opening
6.
facing up) in a container filled with
water until no more air bubbles rise
to the surface.
~ Fig. '
Then press the water filter firmly into
7.
the empty water tank.
Fill the water tank with water up to
8.
the "max" marking.
Place a container with a capacity of
9.
1.0 litre under the outlet.
Touch the "ok" button latte
10.
macchiato to save the setting and
start rinsing.
Operating the appliance en
Touch the "¾" button caffe crema to
11.
exit the menu.
Then empty the container. The
12.
appliance is ready for use again.
Removing the water filter
If the water filter has been removed and
no new one inserted, please select the
appropriate water hardness. ~ "Setting
the water hardness" on page 43

Frost protection

To prevent frost damage during
transportation and storage, completely
empty the appliance beforehand.
Info: The appliance must be ready for
use and the water tank filled.
Place a large container under the
1.
outlet of the milk frother and push
the frother down.
Press and hold the milk button for at
2.
least 5 seconds.
The LED in the button flashes, and
the appliance now heats up.
As soon as steam escapes from the
3.
milk frother, remove the water tank.
Allow the appliance to cool down.
4.
Wait until ) "Water tank empty"
appears.
Use the k button to switch the
5.
appliance off.
Empty the water tank and the drip
6.
tray and thoroughly clean the
appliance.
The appliance can now be transported
or stored.
The brewing unit is now secured
Note:
and cannot be removed.
41