Starting Calc'nclean - Siemens TI353 Série Mode D'emploi

Starting Calc'nClean

D uration: approx. 40 minutes
C a l c ' n C l e a n s e r v i c e p r o g r a m m e
Press and hold the calc'nClean
1.
button for approx. 5 seconds.
( symbol lights up.
Open the door, remove the drip tray
2.
and coffee grounds container and
empty.
Remove and clean the brewing unit.
3.
Place a Siemens cleaning tablet in
4.
the brewing unit and re-insert the
unit.
Re-insert the drip tray and coffee
5.
grounds container and close the
door.
) symbol lights up.
Remove the water filter (if there is
6.
one).
Pour 0.5 litres of lukewarm water
7.
into the empty water tank up to the
mark and dissolve a Siemens
descaling tablet in it.
Re-insert the water tank and place a
8.
large container (approx. 1 litre)
under the outlet system.
calc'nClean flashes, touch
9.
calc'nClean.
The programme starts, cleans and
descales the appliance. calc'nClean
pulses. Duration approx. 20 minutes.
( symbol lights up.
Empty the container, open the door,
10.
empty the drip tray and re-insert.
Service programme en
Close the door and place a
11.
container under the outlet system.
) symbol lights up.
Clean the water tank and replace the
12.
water filter (if removed).
~ Fig. '
Fill with fresh, still water up to the
13.
"max" mark. Place the container
under the outlet system again.
calc'nClean flashes, touch
14.
calc'nClean.
The programme starts and then cleans
and rinses the appliance. calc'nClean
pulses.
( symbol lights up.
Empty, clean and re-insert the drip
15.
tray and coffee grounds container.
The programme has finished. The
appliance is ready for use again.
47