Using Calc'nclean - Siemens TQ5 Serie Mode D'emploi

en Cleaning and servicing
To start the programme, press
4.
a The display will guide you through
the programme.
Empty and insert the drip tray.
5.
Remove and empty the milk con-
6.
tainer.
Clean the milk container, milk tube
7.
and suction pipe.
Fit the components and insert the
8.
milk container.
If there is a water filter, remove it.
9.
Press ⁠ .
10.
Empty the water tank.
11.
Fill a container with 0.5 l lukewarm
12.
water.
Add a Siemens descaling tablet to
13.
the water and stir until the tablet is
fully dissolved.
Pour the descaling solution into the
14.
water tank up to the calc mark and
press ⁠ .
Place the empty container under the
15.
outlet system and press
a The descaling programme will run
for approx. 20 minutes.
Rinse the water tank.
16.
Press ⁠ .
17.
If there is a water filter, insert the wa-
18.
ter filter.
→ "Insert water filter", Page 58
Press ⁠ .
19.
Fill the tank with fresh water up to
20.
the "max" mark.
Press ⁠ .
21.
a The descaling programme takes ap-
prox. 1 minute and rinses the appli-
ance.
Empty and insert the drip tray.
22.
Remove and empty the milk con-
23.
tainer.
Clean the milk container, milk tube
24.
and suction pipe.
66
⁠ .
25.
a The program has ended and the ap-
Using the cleaning programme
Run the cleaning programme when
your appliance prompts you. The pro-
cess takes approx. 9 minutes.
Requirement: The brewing unit is
cleaned.
→ "Cleaning brewing unit", Page 64
1.
2.
3.
4.
a The display will guide you through
5.
6.
⁠ .
7.
8.
9.
a The cleaning programme takes ap-
10.
a The program has ended and the ap-

Using calc'nClean

You can combine the cleaning and de-
scaling programmes using the
calc'nClean service programme. Run
the calc'nClean programme when your
appliance prompts you. The process
takes approx. 43 minutes.
Requirement: The brewing unit is
cleaned.
→ "Cleaning brewing unit", Page 64
Fit the components and insert the
milk container.
pliance is ready for operation.
Press ⁠ .
Use and
and care" and press
Use and
and press ⁠ .
To start the programme, press
the programme.
Empty and insert the drip tray.
Open the ground coffee compart-
ment.
Place one Siemens cleaning tablet
into the ground coffee compartment.
Close the ground coffee compart-
ment and press
Place a container with a capacity of
min. 0.5 l under the outlet system
and press ⁠ .
prox. 7 minutes.
Empty and insert the drip tray.
pliance is ready for operation.
to select "Cleaning
⁠ .
to select "Clean"
⁠ .
⁠ .