Siemens TQ5 Serie Mode D'emploi page 67

Press ⁠ .
1.
Use and
2.
and care" and press
Use and
3.
"calc'nClean" and press
To start the programme, press
4.
a The display will guide you through
the programme.
Empty and insert the drip tray.
5.
Remove and empty the milk con-
6.
tainer.
Clean the milk container, milk tube
7.
and suction pipe.
Fit the components and insert the
8.
milk container.
If there is a water filter, remove it.
9.
Press ⁠ .
10.
Empty the water tank.
11.
Fill a container with 0.5 l lukewarm
12.
water.
Add a Siemens descaling tablet to
13.
the water and stir until the tablet is
fully dissolved.
Pour the descaling solution into the
14.
water tank up to the calc mark and
press ⁠ .
Place the empty container under the
15.
outlet system and press
a The descaling programme will run
for approx. 20 minutes.
Rinse the water tank.
16.
Press ⁠ .
17.
If there is a water filter, insert the wa-
18.
ter filter.
→ "Insert water filter", Page 58
Press ⁠ .
19.
Fill the tank with fresh water up to
20.
the "max" mark.
Press ⁠ .
21.
a The programme takes ap-
prox. 1 minute and rinses the appli-
ance.
Empty and insert the drip tray.
22.
Open the ground coffee compart-
23.
ment.
to select "Cleaning
⁠ .
to select
⁠ .
⁠ .
Place one Siemens cleaning tablet
24.
into the ground coffee compartment.
Close the ground coffee compart-
25.
ment and press
Place a container with a capacity of
26.
min. 0.5 l under the outlet system
⁠ .
and press
a The cleaning programme takes ap-
prox. 7 minutes.
Empty and insert the drip tray.
27.
Remove and empty the milk con-
28.
tainer.
Clean the milk container, milk tube
29.
and suction pipe.
Fit the components and insert the
30.
milk container.
a The program has ended and the ap-
pliance is ready for operation.
Cleaning and servicing en
⁠ .
⁠ .
67